MXR-5842-47 Series Manual Rev. B 2007
2
TABLE OF CONTENTS
TABLE OF CONTENTS........................................................................... 2
SAFETY NOTICES................................................................................... 2
INTRODUCTION ..................................................................................... 3
PARTS LIST.............................................................................................. 4
SYSTEM SETUP ....................................................................................... 5
Camera Power Supply Options ............................................................................................................ 5
Channel Selection................................................................................................................................ 6
Receiver Setup ..................................................................................................................................... 7
Camera Bracket Mounting - Ceilling.................................................................................................... 8
Camera Bracket Mounting - Wall......................................................................................................... 9
TIPS & TROUBLE SHOOTING.............................................................10
SPECIFICATIONS ..................................................................................11
WARRANTY INFORMATION/ TERMS & CONDITIONS ................12
SAFETY NOTICES
I.
THIS DEVICE COMPLIES WITH FCC RULES PART 15.249 OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITONS:
(1)
This device may not cause harmful interference, and
(2)
this device must accept any interference, including interference that
may cause undesired operation of the device
II.
In order to comply with the FCC/IC adopted RF exposure requirements, this transmission system will be installed by an
authorized professional installer of VideoComm Technologies. Installation of all antennas must be performed in a manner
that will provide at least 23cm clearance from the front radiating aperture, to any user or member of the public.
III.
This is NOT an intrinsically safe device. Do not take into area where intrinsic safety is required. Bodily harm may result if
warning is ignored.
IV.
DO NOT OPERATE WIRELESS CAMERA WITHOUT ANTENNA CONNECTED TO ANTENNA PORT. Failure to do
so will result in damage to the unit and void the warranty.
V.
DO NOT OPERATE THE WIRELESS CAMERA WHEN the Receiver is closer than ten feet. The devices may not work
properly and permanent damage can occur.
VI.
The device has been certified by the FCC for use with other products without any further certification (as per FCC section
2.1091.) Changes or modifications not expressly approved by VideoComm Technologies could void the user’s authority to
operate the equipment.
The term “IC:” before the radio certification number only signifies that Industry Canada
Technical specifications were met.
