6
USING YOUR
VAC & BLOW
BEFORE YOU START
•
Ensure that the handle has been
correctly fi tted and is fi rmly fastened to
the machine (see assembly instructions).
•
Always ensure that the vacuum bag is
fi tted to the Vac & Blow before switching
on in both Vac & Blow modes (see
assembly instructions).
•
Your Vac & Blow Electric is controlled by
the ON/OFF switch in the handle. Ensure
the switch is in the off position.
•
Connect to an extension cord. Loop the
extension cord through the handle and
around the cord restraint as shown.
•
Always direct the cord to the rear, away
from the appliance.
•
If a cord becomes damaged during use,
turn off at powerpoint & disconnect the
supply cord from the mains immediately.
Do not touch the cord before
disconnecting the power supply.
•
Do not carry the appliance by the cord.
•
Disconnect the appliance from the mains
supply.
- whenever you leave the machine;
- before clearing a blockage;
- before checking, cleaning or
working on the appliance;
- if the appliance starts to vibrate
abnormally.
•
Operate the appliance only in daylight or
in good artifi cial light.
•
Do not overreach and keep your balance
at all times.
•
Always be sure of your footing on slopes.
•
Walk, never run.
•
Keep all cooling air inlets (shown below)
clear of debris.
It is recommended that the Vac & Blow
should be connected to the mains through
a Residual Current Device (RCD) with a
tripping current of not more than 30 mA.
Always use an extension cord with heavy duty
insulation that is designed for outdoor use.
USING VACUUM MODE
•
Ensure the Vac & Blow is switched off.
•
Turn function switch clockwise until the
arrow on the switch lines up with the
arrow for “Vac” mode.
•
Switch on at the handle – Always do this
from a standing position. Never while
kneeling or sitting next to the Vac & Blow.
•
“Vac” away debris by moving the Vac &
Blow over the area to be cleared.
ON/OFF Switch
Cord Restraint
Cooling
Air Inlets
Not
for
Reproduction
