UniOP
50
In order to meet the front panel protection classifications, proper installation
procedure must be followed:
•
the borders of the cutout must be flat
•
screw up each fixing screw until the plastic bezel corner get in contact with the
panel.
•
The cutout for the panel must be of the dimensions indicated in this manual.
•
Two types of gaskes are delivered with the UniOP panels, depending on the
model, rectangular or linear.
Applying the rectangular gasket
•
The gasket should be applied around the cutout prepared for the panel being
careful not to place it under tension
•
The gasket should be replaced every time that the panel is dismounted and
remounted in its place
CUT-OUT
GASKET
UniOP PANEL
Figure 43 - panel with rectangular gasket installation
Summary of Contents for UniOP BKDC-46
