B E Y O N D M O T I O N
Vicon Motion Systems
Page 7
•
•
•
•
•
•
•
•
•
•
Product configurations and software options - Vicon Lock Studio
This page provides information relating to the EU Declaration of Conformity (Vicon Lock Studio).
Conformity of the Metrological Performance of CLASS 1 Products
Manufactured in Accordance with Annex VII, Section 5 of the Medical Devices
Directive 93/42/EEC of the 14
th
June 1993
As amended by EU Council Directive 2007/47/EC of 5
th
September 2007
We, Vicon Motion Systems Limited
Unit 6, Oxford Industrial Park
Mead Road, Yarnton, Oxford, OX5 1QU
UNITED KINGDOM
declare that the VICON LOCK STUDIO providing analogue-digital conversion within the VICON Vantage or Vero Gait Analysis System manufactured by VICON
MOTION SYSTEMS LIMITED has been tested prior to shipment and meets the following metrological performance:
Measurement Criteria
Supporting software: Nexus 2.10 or later, Shogun 1.4 or later, Tracker 3.8 or later.
Analogue Digital Conversion
Resolution to ± 10 mV mean and ± 10 mV (1 Standard Deviation).
Synchronization
Difference within one video frame.
Lock Studio safety information
The following guidance helps you to ensure the safe operation of your Vicon system, including the use of Lock Studio.
To avoid introducing a safety hazard and possibly damaging the system, please ensure that an adequate and good-quality alternating current (AC) power source
is available.
For guidance, see the ratings statement on the rear of the connected PoE or PoE+ unit. Also ensure that any computers and peripheral devices are set to be
electrically rated to operate with the AC power available in your location.
When working with Vicon systems, observe these safety precautions:
To prevent electric shock, plug all system components into properly grounded power sources. These cables must be equipped with three-prong plugs to
ensure proper grounding. Do not use adapter plugs or remove the grounding prong from a cable.
Ensure nothing rests on the system cables and that cables are not located where they can be stepped on or tripped over.
Do not spill food or liquids onto any electrical component of the system. If any component gets wet, immediately contact Vicon Motion Systems or your
nearest agent or distributor for advice.
Do not push any objects into the slots of any unit of the system. Doing so can cause fire or electric shock by shorting out internal components.
Keep all system components away from radiators and heat sources, and do not block cooling vents. Avoid placing loose papers underneath any components.
Do not place any components on closed-in units or on a bed, chair, etc.
Replace fuses with the same type and rating for continued fire protection.
Do not use outside, near water, in an environment exposed to anesthetic or other explosive gases, or in mobile applications.
Warranty information
The warranty for your Vicon system begins after installation. For full details on warranty scope and conditions, refer to the Vicon Terms and Conditions of Supply
for your Vicon system.
