Installing the Kollector Pro
After the recorder is mounted permanently, follow the steps in this section to install the Kollector Pro unit
hardware.
•
Step 1: Connecting the Hardware
, below
•
Step 2: Connecting External Hardware to the Kollector Pro
, page 11
•
Step 3:
Connecting Looping Cables
,
page 15
•
Step 4: Connecting the Power Supply
, page 16
IMPORTANT NOTES:
The connection of external hardware may require simple hand tools. Do not apply power or plug-in the
recorder to any outlet until instructed to do so.
Disable the AC power to prevent installer injury and damage to the unit.
Before beginning the hardware installation, ensure that the following environmental conditions have been met:
•
The surface on which the ViconNet hardware is to be placed must be level.
•
The room or area designated for the ViconNet hardware installation must be well ventilated.
Step 1: Connecting the Hardware
This procedure describes the various hardware connections that must be performed in order to operate the
system.
To connect the ViconNet hardware:
1. Perform the following connections (refer to Figure 3-1 on page 6 and Figure 3-2 on page 7):
1.1 Locate the keyboard on a flat surface near the recorder. Connect the keyboard by inserting its
connector into the correct port.
1.2 Locate the mouse on a flat surface near the recorder. Connect the mouse by inserting its connector
into the correct port.
1.3 Position the monitor in a permanent fixed location near the recorder. Connect the monitor by inserting
its VGA connector into the VGA Monitor Output port.
1.4 Insert one side of a standard LAN cable to the Network Port’s RJ-45 connector. Insert the other RJ-45
connector into the LAN side of the network.
1.5 Gather and locate all camera video input cables near the rear of the recorder. Insert each BNC-M into
its respective Video (Camera) Input port (1 – 16).
10
•
Installation
XX128-05-00 Rev 908 Kollector Pro Network Digital Video Recorder
