Unit Components
This section describes the Kollector Pro unit's front and rear panels.
Front Panel Controls and Connections
The following picture shows the Kollector Pro
front panel. Each panel component is described in the table
below.
Figure 3-1: Front Panel Layout
The Kollector Pro's front panel contains the following components:
•
Power Switch:
Used to power on the recorder (for more details, refer to
Powering On the Recorder
, page
17). Note that some units (30, 60 and 120 fps models) come from the factory set for either 115 VAC or
230 VAC. Verify that the switch on your unit is set correctly. The red switch is located on the rear panel,
next to the plug receptacle. The voltage setting value is displayed on the switch; if it is required that this
setting be changed, disconnect power from the unit and use a small screwdriver to push the switch up for
115 VAC or down for 230 VAC.
•
HDD LED Indicator:
Used to display HDD activity status.
•
Power LED Indicator:
Used to display the power status (ON means recorder on and OFF means
recorder off).
•
CD-RW Drive:
Used as a high-capacity removable data drive.
•
Front Cover:
Used to protect the
Kollector Pro's front panel
from unauthorized use.
•
Keylock:
Used with the provided key to lock the front cover.
6
•
Installation
XX128-05-00 Rev 908 Kollector Pro Network Digital Video Recorder
