EN - English - I
nstruc
tions manual
7
6.1.7 Blower installation
h
Not usable in housings with cooling device
and
wiper installed.
h
The blower kit should be assembled
according to the instructions to ensure a
correct air circulation inside the housing.
This chapter describes how to install the blower
kit option into the housings that are not equipped
with it. The blower kit can be supplied in 3 different
configurations depending on the power supply
voltage.
Open the housing as described before.
Fix the blower inside the body of the housing, using
the corner bracket and supplied screws.
Blow direction
Fig. 09
Using the screws supplied with the kit, assemble
the power supply with the support bracket (01) and
the corner attachment bracket (02), using the points
provided for this.
01
02
Fig. 07
Insert the 6-pin connector at the end of the cable
into the correspondent one on the support circuit,
identified by J7 (
).
Fig. 08
Close the housing.
h
When the circuit is powered by an external
source care must be taken to the type
of voltage used and, depending on
requirements, to the correct power supply
kit. When installing the optional camera
power supply it is not necessary to remove
any previously installed component.
Summary of Contents for HOV
Page 1: ...HOV Side opening aluminium housing ...
Page 2: ......
