Vicon HOV, Manual

Page: 10 / 14

EN - English - I
nstruc
tions manual
8
Depending on the inclination of the housing, the
direction of the fins must be such to prevent water
entering in case of rain.
To guarantee the IP44 weatherproof, install the
housing on the support following the inclination
limits as shown in the picture.
0˚
45°
45°
Fig. 11 Maximal rotation on the transversal axis: 0˚.
Maximal inclination on the longitudinal axis: +/- 45˚.
Open the housing as explained above.
Make the electric connections for the cooling device
to the terminal marked J8 FAN (
Fig. 03, page 6 ).
In this circuit the camera can be powered from the
terminal marked J2 (
Fig. 03, page 6 ). The power for
the optional heating system can be taken from the
terminal marked J3 HEATER (
Fig. 03, page 6
). See
chapter "6.1.5 Heater installation", page 6 .
Close the housing following these instructions in
reverse.
g If the circuit is powered from an external
source, special attention must be payed
to the voltage. The housings with this
device can be powered with 12Vdc, 24Vac
or 230Vac voltage and the correct power
supply kit must be chosen.
6.1.7.1 100-240Vac power supply
Insert the 2 pin connector at the end of the cable into
the corresponding one indicated by J8 FAN on the
support circuit (
Fig. 03, page 6 ).
Install the camera power supply supplied with the
blower kit as described in the chapter
"6.1.6 Camera
power supply installation", page 6 .
Close the housing.
6.1.7.2 12Vdc or 24Vac power supply
Insert the 2 pin connector at the end of the cable into
the corresponding one indicated by J8 FAN on the
support circuit (
Fig. 03, page 6 ).
In this housing the ventilation kit is supplied with a
connector fitted with the appropriate connections to
make the support circuit compatible with operation
at the power supply voltage available. This connector
should be inserted into the correspondent one
marked J7, on the supplied circuit.
Close the housing.
6.1.8 Cooling device
This section describes how to connect the housing
with installed cooling device.
No other components need installing inside these
models, as each one is supplied complete with all the
necessary parts.
Special attention must be paid to the position of the
air intake filter fins when installing the housing.
IN
OUT
Fig. 10