![Vicon Andex 844 Assembly Instructions Manual Download Page 24](http://html1.mh-extra.com/html/vicon/andex-844/andex-844_assembly-instructions-manual_1012854024.webp)
Crate packaging
24
Connecting the
steering rods
The steering is preset at the factory.
Fit the lower part of the bearing shells to the main frame.
Place the steering rod into the bearing shells.
Connect the clevis of the rear steering rod with the adapter of the
front steering rod.
Insert the threaded pin.
Secure the threaded pin with a self-locking nut.
The lock nut for the front steering rod is glued in place at the factory.
When adjusting the steering, only correct the length of the rear
steering rod.
Pay close attention to the alignment of the holes of the steering rods.
The holes of the steering rods must be aligned vertically to the ground
and parallel to each other.
After adjusting the steering, secure the steering rod with the lock nut.
Clevis
Front
steering rod
Bearing shell
Rear
steering rod
No.
Quantity
Part
1
1
Front steering rod
2
1
Rear steering rod
3
1
Threaded pin
4
1
M 16 self-locking nut
5
2
Bearing shells
Rear
steering rod
Front
steering rod
Clevis
Threaded pin
Lock nut
Secured lock nut.
Do not loosen.
Summary of Contents for Andex 844
Page 4: ...Table of contents 4 ...