Preparations on the field
59
Two single swaths
When both swath formers are being used, no swivel action may pass
the central axis to the left in the direction of travel. There is a risk of
collision. Damage to the machine may be caused as a result.
Fold the machine into its work position.
Switch off the tractor and secure it.
Switch off the pilotbox.
Remove the ignition key.
Remove the additional swath former from the transport holder on
the machine, mount it on the front rotor, and secure with a T-bolt.
Adjust the additional swath former, leaving a maximum distance of
450 mm from the deflector bar, and secure in place.
Check that the rear swath former is fitted into the rear hole pattern.
Push the rear swath former as far back as possible and secure in
place.
Adjust the rear swath former, leaving a maximum distance of
600 mm from the deflector bar, and secure in place.
The following illustrations depict the machine as follows:
•
With both swath formers in position
•
With the rear swath former in the front hole pattern and pushed as
far backwards as possible.
→
Chapter»Additional equipment«, section »Additional swath
former« page 86.
Single swaths
Collision danger
In the “Two single swaths” work position, both swath formers are
used. Adjustments must be made to both swath formers. There is
a risk of collision. Damage to the machine may be caused as a
result.
Risk of collision
Rear swath former
Rear swath former
Deflector bar
600 mm
Front hole pattern
Direction of travel
Summary of Contents for Andex 714 T Vario
Page 4: ...Table of contents 4 ...
