Delivery and assembly
30
Shortening the PTO
shaft
Pull the PTO shaft apart and connect one half to the tractor PTO
stub shaft drive and the other half to the machine and secure them.
Place the two shaft halves next to each other and:
•
Check for a minimum of 200 mm overlap (b).
•
Check that the PTO shaft is not blocked at one end
(minimum distance (a) = 20 mm).
Shorten the slide tube and guard tube by the same dimension.
Deburr the ends of the tubes.
Remove the swarf.
Grease the sliding surfaces well.
Fitting the PTO shaft
Make sure that you fit the PTO shaft in the correct installation position.
There is a marking on the guard tube of the PTO shaft.
Check the length of the PTO shaft and shorten it if necessary.
Place the PTO shaft onto the PTO stub shaft of the machine.
Secure the PTO shaft with a locking pin.
Marking on the guard tube
Summary of Contents for Andex 714 T Vario
Page 4: ...Table of contents 4 ...
