Vicom Systems FC-FC3, Installation And User Manual, Page: 32 / 102

SV Router FC-FC 3 – Installation and User Guide – Sun Release
18
Cable SV Router to T3 Partner Group
From this point forward, to ease confusion, the routers will be referred to as SV Router A and
SV Router B, as depicted in
Figure 2-1 "T3 Setup Overview" on page 19 . And the remote
management servers will be referred to as primary or secondary.
1. Ensure you power off all devices before connecting them.
2. Using an optical cable, connect the device side of SV Router A’s FC port to one T3 partner
group port. See Figure 1-2 "Vicom SV Router FC-FC 3 – Rear" on page 3 to determine the
location of the SV Router’s device side port.
3. Using an optical cable, connect the device side of SV Router B’s FC port to the other T3
partner group port.
4. Using an optical cable, connect the two remaining device side FC ports of SV Router A
and SV Router B together.
Connection Test
1. Power on the T3 Partner Group then the SV Router.
2. Start the communication software.
3. Open the communication terminal, and type hello.
4. Enter ? to display the
User Service Utility Key Assignments:
5. Enter 2
'2': Show LUN Map
6. Each SV Router should see four LUNs (T0, T1, T2, T3) as seen in Figure 2-1 "T3 Setup
Overview" .
7. Repeat steps 1-4 for both routers.