Vicom Systems FC-FC3, Installation And User Manual, Page: 28 / 102

SV Router FC-FC 3 – Installation and User Guide – Sun Release
14
• Press the Enter key to accept changes to the device side.
• Press the Enter key to accept changes to all the SV Router interfaces.
Caution ! If you reboot the router before saving your changes the second
time, the changes will not be saved.
4. Enter H to configure the SV Router’s host side.
The SV Router’s FC port are the two upper FC ports on the rear of the SV Router. See
Figure 1-2 "Vicom SV Router FC-FC 3 – Rear" on page 3 to determine host-side port
location. To enable SV Router compatibility with differing servers, the user may change
the host-side FC topology and mapping algorithms. Here the host-side will be configured
for: point to point mode, command queue depth of 736 (default), and direct LUN mapping
(default).
Note: Different host operating systems and host bus adapters scan drives in different ways.
Please refer to your operating system and host bus adapter manuals for information
concerning LUN specifications.
• Toggle P until you Set Operating Mode to Pt-to-pt mode.
Operating Mode:
Current: Pt-to-pt mode.
Default: Arb Loop mode.
• Press the Enter key to accept changes to the host side.
• Press the Enter key to accept changes to all the router interfaces.
Caution ! If you reboot the router before saving your changes the second
time, the changes will not be saved.