Basic Operation
-12-
2-1
Powering On/Off the Balance and Checking
Operation
Turning the power of the balance on and off
1
Turn the power on.
.
→0
←
ｇ
Press the [On/Off] key.
The scale switches to weight display after the zero
point check finishes.
If there is an external disturbance such that the scale cannot initialize or if there is something on the pan
when the power is turned on, “on 0” will blink continuously. Remove the object from the pan and when the
scale stabilizes the scale will switch to weight display.
If the “on 0” state continues for a certain amount of time, the display will read E*-Err. Please see p.75 for
the details about this error.
2
Turn the power off.
Press the [On/Off] key again.
The display lights out.
参 考
- The status of the balance obtained when the power is turned on is the measuring mode that
was used before the power was turned off. For example, if the power is turned off in parts
counting mode, the balance is started up in parts counting mode when the power is turned
on.
- When the balance is stable, “
{
” is shown in the display.
.
ｇ
○
If the balance is not stable, this “
{
” lights out. The balance may be under an external
influence such as wind and vibration.
Changing settings by referring to “Section 5-4
Improving the Stability of the
Balance” (P. 55) can improve stability.
-
The bar graph is displayed in the display. This graph shows the current weighted state as a
ratio to the weighing capacity. The closer to the right side of the bar, the closer the weight is
to the weighing capacity.
.
ｇ
Reference
