Vibra AJ-1200E, Operation Manual

Page: 32 / 47

29
9.2 Calibration of AJH-E Series
Applicable models: AJH-220E, AJH-320E, AJH-420E, AJH-620E, AJH-2200E, AJH-3200E, AJH-4200E
※
Span adjustment should be performed with the balance installed perfectly level and without any load
on the measurement pan.
1 Invoke the span-adjustment function.

押し続ける
 
指を離す
Hold down.
Release your
finger.
Hold down the Function key, then
release your finger when the display
switches from [

] to [
 

].
2 Start span adjustment.
 
Zero/Tareキーを押しながら
Functionキーを押す
② ①
同時に離す
CAL
 
Press the Function key while
holding down the Zero/Tare key.
Release both
fingers at the
same time.
Press the Function key while holding
down the Zero/Tare key, then release
both fingers simultaneously. Display will
change to a flashing [
 
] and the
zero-point will be calibrated
automatically.
3 Zero-point calibration
CAL
 
CAL


Once zero-point calibration is
completed, display switches to [


]. Calibration now proceeds to that
of the weighing capacity point.
4 Calibration of weighing capacity point
CAL


CAL
 
Slowly and fully turn the calibration knob
in the direction of [Calibration].
The balance assumes the state where
the calibration weight is loaded on the
measurement pan.
The display starts flashing and the
balance automatically adjusts the
weighing capacity point.
Calibration