Viavi Certifier40G, User Manual, Page: 30 / 36

4
Chapter 4: Configuring an AUTOTEST
After configuring the system settings, follow these steps to set up an AUTOTEST.
1. Press the SETUP button > Project Settings
a. Site – Create or select a Site
b. Operator – Create or select an Operator
c. Label Source – Select cable labelling scheme. Load labels from USB flash drive
if using List Based Testing (LBT).
d. AutoSave – Enable option for Certifier to auto save every PASS result.
2. Press the SETUP button > Test Settings
a.
Test Limit – Select a test limit
b.
Cable – Create a custom or select cable from list. Select “Generic” if unsure.
c.
Modal Bandwidth - Choose the modal bandwidth of the cable under test.
Leave option unchanged if unsure.
Please ensure you have the following components before conducting the test;

Certifier, Local & Remote units

Single Mode Testing Kit OR

Multi-Mode Testing Kit OR

Encircled Flux Multi-Mode Testing Kit
Single Mode Testing Kit Multi-Mode Testing Kit EF Multi-Mode Testing Kit