Viatron AA800EZe, User Manual

Page: 26 / 36

26
AA800EZe rev.03
AA800EZe
MONITORING FUNCTIONS 6.
6.1. Alarm Memory
The Agri-Alert has an alarm log menu in which
details about the previous 50 alarm situations
are kept in memory. Below is a list of alarm
information saved in the alarm log:
• Zone number;
• Type of alarm;
• Moment at which the alarm was declared
(time & date);
• Identity of the user who acknowledged the
alarm (if applicable);
• Moment at which the alarm has been ac -
knowledged (time & date).
Select: 1.
• Alarm Memory
Alarm Memory
Siren
Failure
Not Connected
1 Jan 200X 12:00:00 am
Installer
1 Jan 200X
12:00:15 am
1/8
Use the right and left arrow keys to step 2.
from an alarm entry to another.
Alarm
M emory
6.2. Current Conditions
The Current Condition menu gives the cur-
rent status of the inputs and outputs of the
Agri-Alert system:
1 2 3 4
75.2 74.7 76.6 Open
5 6 7 8
Open Close
Outdoor T° 81.3
Zones 1-8:
The Agri-Alert show the current status of
each zone input (open/close status of a dry
contact or temperature reading).
Outdoor Temperature Reading:
If an outside temperature sensor is used,
the system displays the current outside
temperature; this reading is replaced by
3 question marks if the sensor is not con-
nected correctly.
Status Icons:
6.3. Event Buffer
The Agri-Alert keeps a record of all system
events such as alarms, arming/disarmings,
acknowledgments, dialouts, calls made to
the system, parameter adjustments, etc. The
event buffer can contain up to 500 events.
When the buffer is full, the oldest events are
replaced by most recent events.
Select: 1.
• Main Menu
• System Auxiliaries
• Event Buffer*
* Accessible with the Master password only (sec. 3.2).
Event Buffer
Start Call Delay
Modif.
1min
Start Call Delay
Modif.
1min
23/200
7. INSTALLATION CHECK
LIST
The help menu is there to remind you of all
installation steps.
Select: 1.
• Main Menu
• Help Menus
• Install Check List
A list of all installation steps is displayed:
System Ground Connected •
Zone Inputs Wired •
Phone / Siren / Relays connected •
System Programmed •
System Function Tested •
End User Instructed •
16VAC power
is OK
Battery fully
charged
16VAC power
is down
Battery in
discharge
(the system
runs on the
battery)
16VAC power
is unstable
Low battery
(the system
runs on the
battery)
12VDC output
is OK
Battery is
recharging
12VDC output
problem
Recharge sus-
pended
12VDC output
unstable
Battery is dis-
connected (or
not detected)
Phone is on
hook
Relay 1 is off
(deactivated)
Phone line is
disrupted
Relay 1 is on
(activated)
Phone card is
not connected
Relay 2 is off
(deactivated)
Phone is off
hook (The sys-
tem uses the
phone line)
Relay 2 is on
(activated)