16
090427.02
vetus®
Waste water control panel WWCP
4
Set-up procedure
The panel must be set up after it has been connected.
The set up procedure will be exited automatically if no key is pressed for more than a minute,
or by pressing the on/off key.
• Switch on the power.
Is the ‘ON’ LED on?
Ignore all other LEDs.
• Press the key once.
• Press and hold the key for approx. 10 seconds.
• Hold the float in the FULL position.
• Press the
key once.
• Press the
key.
Explanation:
- Float sensor:
hold the float in the highest position.
- Ultrasonic sensor: hold the sensor close to a reflective surface.
Note: The sensor must be held steady in this
position for approx. 10 seconds.
OR
• Press the
key to
bypass setting
the ‘Maximum
tank level’.
Setting the ‘Maximum tank level’.
YES
NO
Always start the set up procedure from the beginning, even if only one setting has to be
changed!
A
Continue on the next page.
Make sure that an
ultrasonic sensor has been
calibrated; see ‘Installation
instructions SENSORA’
090429.01, ‘Calibration’.
