Step 4:
Step 5:
Step 6:
Step 7:
Slide and rotate the sensor until the alignment mark just
touches the spacer tip on the magnet. (Fig. 4)
Route the sensor wire up the fork blade and secure it
with the tape. Wrap excess wire around the front brake
cable housing, leaving enough slack to attach the
mounting bracket easily to the handlebar and allow for
movement of the bar and stem.
CAUTION:
When
installing the speed sensor on a suspension fork,
make sure that the fork is fully extended to ensure
there is enough wire to reach the mounting bracket
properly. Excess sensor wire should be taped down
or wrapped around the brake cable housing for
safety.
Snug the zip tie down to hold the sensor in its final
position.
Remove the spacer and verify that the magnet and
sensor spacing stayed the same. (Fig. 5)
Note:
Do not use a zip-tie tightening tool or a third hand tool
when doing the final tensioning of the zip-ties. This can tear and
damage the sensor or transmitter.
