Vestil CCM Series, Instruction Manual

Page: 5 / 8

Table of Contents Rev. 12/8/2020 CCM MANUAL
Table of Contents Copyright 2020 Vestil Manufacturing Corp. Page 5 of 8
NATIONAL STANDARDS
According to US Federal Occupational Safety and Health Administration (OSHA) Rule 1910.178 (29
CFR 1910.178; the “Rule”), this device is a front end attachment for a lift truck whenever it is mounted on
the forks of a lift truck. The Rule incorporates American National Standard ANSI/ITSDF B56.1 (the
“Standard”) published by the Industrial Truck Standards Development Foundation (ITSDF) on its website
( www.itsdf.org ). The standard is freely downloadable at http://www.itsdf.org/cue/b56-standards.html . Before
putting this product into service, you must acquire a copy of the Standard. Apply all relevant parts of Part II:
For the User. If instructions provided in this manual conflict with the Standard, then you should apply the
instructions in the Standard. If you find any conflict, Vestil requests that you immediately share them with
its
TECHNICAL SERVICE personnel. Contact information for TECHNICAL SERVICE appears on the cover
page of this manual.
INSTALLING THE COIL MOVER
Step 1: Take the tines off of the carriage of your fork truck.
Step 2: Rotate the latch lever to the open position. Set the left side of the upper carriage bracket on the upper carriage
crossbar of your lift truck.
Step 3: Slide the upper carriage bracket along the carriage crossbar. Adjust position to allow the lower carriage
bracket to fit into the notch in the lower carriage crossbar (of the forklift). The notch is probably located at the center of
the crossbar. Next, slide the back plate to the left or right as necessary to center the coil mover on the carriage.
Step 4: Latch the coil mover to the carriage by moving the latch lever back to the closed position.
[NOTE: The latch lever will only rotate back to the closed position if the latch aligns with a notch in the upper crossbar.
If necessary, adjust the position of the carriage plate until the latch aligns with a notch.]
CARRIAGE
PLATE
UPPER
CARRIAGE
BRACKET
Upper
carriage
crossbar
(of forklift)
NOTE: The latch can be attached to either the
left or right side of the upper bracket (shown
installed on left side).
LATCH LEVER
Turn latch lever to open position
(shown closed)
Set the upper carriage
bracket on the carriage
crossbar of your forklift.
Slide the bracket along the
carriage crossbar until the
lower carriage bracket fits
into the notch in the lower
carriage crossbar of your
forklift.
LOWER CARRIAGE BRACKET
Left side
Right side
COIL STOP