It can be levelled by screwing the adjustable feet at the front of the appliance up or down (fig.
2). Use a spirit level to check that the appliance is absolutely level sideways.
The appliances 45 and 38 can be installed as built-in units in kitchen elements or be placed
free-standing (fig. 3). At built-in condition ensure sufficient airflow through the kitchen base in
front of the appliance. The total cross section of the opening must be as described in fig. 3, and
individual air duct clearance must be at least 5 mm.
The door can be changed from right-hinged to left-hinged and vice versa as follows:
1) Screw 2) Bottom hinge, right 3) Door pin 4) Top hinge, right 5) Door 6) Cabinet 7) Top hinge,
left 8) Bottom hinge, left.
Ensure that the cabinet is not connected to the mains and place the cabinet on the back
Dismount the screws (1) SUPPORT THE DOOR! See fig . 6.1
Dismount the door by pulling it forwards and free from the top hinge. See fig. 6. 2
Dismount the right top hinge and save it for later use. See fig. 6.3
Mount the left top and bottom hinge enclosed (7 + 8). See fig. 6.4
Remount the door pin previously dismounted (3) in the bottom hinge
Mount the door in the top hinge (7) towards the door pin (3), tighten the door pin (1)
Move the handle from left side to right side
Lift up the cabinet again and wait 1 hour before connecting it to the mains to avoid oil in the
cooling system
The appliance is intended for connection to alternating current. The required voltage (V) and
frequency (Hz) are stated on the nameplate inside the appliance. Power must be connected via
an independent wall socket outlet.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a
similar qualified person in order to avoid a hazard.
This appliance complies with CE marking regulations, directives and standards.
The electronic control ensures that the set temperatures are maintained in the cabinet
compartments. This is accomplished by complex control of the refrigerating system, the
heating element, and the fan. Following any power failure, the temperature setting is reverted
to factory defaults:
Upper compartment: 6°C
Lower compartment: 12°
The electronic controls have the following functions:
•
Temperature setting
•
Temperature display
•
Automatic defrosting
•
High and low temperature alarm
•
Light on/off
•
Cabinet on/off (push and hold for 3 secs)
The display shows the actual temperature in the compartments. The temperature display has a
built-in filter that simulates the actual temperature in the bottles. The displayed temperature is
therefore not affected by transient fluctuations in air temperature.
The temperature is set using the two buttons on the control panel. By pushing a temperature
button, the display changes from actual temperature to set value.
Build-in
Change of hinge side 32-45
Electrical connection
Technical data
Operation and function 32-45
Electronic control
Temperature display
Temperature setting
9
rigo
Italiano
EnglishFrançaisDeutsch
