English - 72 -
Switching On/Off
To Switch the TV On
Connect the power cord to a power source
such as a wall socket (220-240V AC, 50 Hz).
To switch on the TV from standby mode
either:
ĐƋ
Press the
Standby
button,
Pro/-
or a numeric button on the remote control.
ĐƋ
Press the
Standby
button or
Programme
+/-
on the TV.
The TV will then switch on.
To Switch the TV Off
Press the
Standby
button on the remote
control or press the
Standby
button on the
TV, then the TV switches into standby mode.
To power down the TV completely, unplug
the power cord from the mains socket.
NOTE:
When the TV is switched into standby
mode, the standby LED can blink to indicate
that features such as Standby Search, Over Air
Download or Timer is active. The LED can also
blink when you switch on the TV from standby
mode.
First Time Installation
When turned on for the first time, the
language selection screen is displayed. Select
the desired language and press
OK
.
On the next screen, set your preferences
using the directional buttons.
NOTE:
Depending on the Country selection
you may be asked to set and confirm a PIN at
this point. The selected PIN cannot be 0000.
You have to enter it if you are asked to enter
a PIN for any menu operation later.
About Selecting Broadcast Type
Digital Aerial:
If
Digital Aerial
broadcast
search option is turned on, the TV will search
for digital terrestrial broadcasts after other
initial settings are completed.
Digital Cable:
If
Digital Cable
broadcast
search option is turned on, the TV will search
for digital cable broadcasts after other initial
settings are completed. According to your
other preferences a confirmation message
may be displayed before starting to search.
Select
YES
and press
OK
to proceed. To
cancel operation, select
NO
and press
OK
.
You can select
Network
or set values such as
Frequency
,
Network ID
and
Search Step
.
When finished, press
OK
button.
NOTE:
Searching duration will change
depending on the selected Search Step.
Satellite:
If
Satellite
broadcast search option
is turned on, the TV will search for digital
satellite broadcasts after other initial settings
are completed. Before satellite search is
performed some settings should be made.
Digiturk Option
If desired, you can search and store Digiturk
channels. Before the satellite search starts, a
menu will be displayed where you can select
to install
Digiturk
channels. Set the
Install
Type
as
Operator
and than set the
Satellite
Operator
accordingly.
If you select
Digiturk
operator, next menu
item will be
Select Satellite
. Set the satellite
and press
OK
to proceed.
If you select
Standard
as
Install Type
and
press
OK
,
Antenna Type
menu will be
displayed first. You can select
Antenna Type
as
Direct
,
Single Satellite Cable
or
DiSEqC
switch
by using “ ” or “ ” buttons.
ĐƋ
Direct:
If you have a single receiver and a
direct satellite dish, select this antenna type.
Press
OK
to continue. Select an available
satellite on the next screen and press
OK
to scan for services.
ĐƋ
Single Satellite Cable:
If you have multiple
receivers and a single satellite cable system,
select this antenna type. Press
OK
to
continue. Configure settings by following
instructions on the next screen. Press
OK
to scan for services.
Summary of Contents for 49FB7500
Page 1: ...TELEViZYON KULLANIM KILAVUZU SMART 49FB7500 49 LED TV OPERATING INSTRUCTIONS ...
Page 112: ......
Page 113: ......
Page 114: ......
