VESDA by Xtralis
VESDA VLF-500 Product Guide
www.xtralis.com
7
2.3
Installing the Detector
In all installation cases the mounting bracket must be fitted (upright) as shown in Figure 2-4 on page 8.
Note:
Ensure the mounting surface is flat. This will permit an air tight seal to be achieved between the
sampling pipe and the tapered air ports on the detector.
Warning:
Prior to drilling the attachment holes for the mounting bracket, ensure that all mounting surfaces
(i.e. walls, cabinet sides, etc.) are clear of electrical wiring and plumbing.
Avertissement :
Avant de percer les trous de fixation pour le support de montage, assurez-vous que toutes
les surfaces de montage (c'est-à-dire les murs, les côtés des armoires, etc.) ne comportent
pas de câbles électriques ni de tuyaux.
Where the pipe network and cabling are already fitted, the bracket can be used to aid alignment of the detector
with the pipes. The Installation procedure below explains this process.