6
TM30 User Manual v. X1.0
2.3. Receiver TMR30
Figure 2.3.
TMR30 user interface
Nose section with antennas
:
Nose has three integrated antennas:
Capacitive antenna for Monitor modes
and Open wires mode, close range
antenna for Near cable mode and rod
probe for Cable-route mode.
Power button
:
To switch the device on and off. Level bar will
display battery level while start-up or if Power
button is pressed briefly during use. Device
always starts to the same mode that was used
the previous time. A long press during start-up
prevents automatic switch-off function.
Level
bar:
LED bar display for indicating receiving signal
strength.
MODE
buttons:
Use these up & down buttons to choose the
right Trace or Monitor mode.
GAIN
buttons:
Use these up & down buttons to choose suitable
receiving sensitivity at which signal audio and
Level
-bar won’t get overdriven.
Trace
modes are for receiving signals
generated by the transmitter. One of three
LEDs displays which mode is active.
Monitor
modes are to monitor signals other
than those generated by the transmitter. One
of three LEDs displays which mode is active.
Speaker
for indicating received tracing signal
sound and for internal sound signals & beeps.
Battery compartment
is located at the back of the device. Lid has two
screws. Device operates with four 1.5V LR3 (AAA) batteries. Rechargeable NiCd
or NiMH cells can be used too but they have to be charged in a separate
charger. If batteries are low, active
MODE
LED will blink.
Work light
:
The LED light under the nose turns on and off
by briefly pressing Power button.
