Vertiv Liebert XDU 060, Installer/User Manual

Page: 22 / 75

4.5 Unpacking the Domestic Shipped Unit
1. Use a 9/16-inch (14 mm) socket drive or wrench to remove the lag screws (four places typical) that secure the
ramp to the pallet, see Figure 4.2 below. Set the ramps aside for use later when preparing tomove the unit
from the pallet.
2. Remove the exterior packaging from around the unit.
NOTE: The bag may remain in place to protect from dust and to protect the unit panels, or it may be removed for
immediate installation.
3. Remove the bag from the unit when ready to move off the pallet and install the unit. See Removing Units from
the Pallet on the facing page.
Figure 4.2 Lag Screws that Secure Ramps
Vertiv | XDU™ Liquid to Air Heat Exchanger for Chip Cooling
18