3.
Enter the path and filename for the data log.
NOTE: The default filename is sys-data.log.
4. Click the Export icon when finished.
5.
Click the Flush or Download icon at the upper-left of the window to clear or download the data log.
Backup and Restore
An administrator can configure an FTP site to back up a configuration file or restore a configuration from a backup file.
To configure the backup file location:
1.
From the side navigation tree of the
System
tab, click
Notification - Backup and Restore
.
2.
Check the radio button next to the FTP Site and enter the IP address, username and password for the FTP site
to receive the data log. Then enter the path and filename for the configuration file.
-or-
Check the radio button next to Local, click
Choose File
, browse to the location to save the file and enter a name
for the configuration file.
3.
Click the Save icon.
To back up the configuration:
Click the Save Configuration icon at the upper-left of the window and click
OK
.
To restore from the last saved configuration:
Click the Restore Configuration icon at the upper-left of the window and click
OK
.
Using a USB memory stick
A memory stick can be inserted into the RPC2 module's USB port using a Type A female to micro A/B male adaptor. You
can use a memory stick to facilitate the initial setup of networking, protocol and device configurations.
Each RPC2 module's .csv configuration file is uniquely saved according to its MAC ID. To facilitate mass configuration,
multiple .csv files can be saved to the memory stick and then edited in a spreadsheet program before being loaded back
into the respective module.
To back up a configuration to a USB memory stick:
1.
Insert a memory stick that does not already contain the module's unique configuration file into the module's
USB port.
2.
After a single beep, the module begins to save the configuration file to the memory stick.
3.
After three consecutive beeps, the backup is complete and the memory stick is shut down for safe removal.
4. Remove the memory stick and repeat as desired for additional modules.
To restore a configuration from a USB memory stick:
1.
Insert a memory stick that contains the module's unique configuration file into the module's USB port.
2.
After five consecutive beeps, the restoration begins. To abort the restoration, remove the memory stick before
the fifth beep.
3.
After three consecutive beeps, the restoration is complete and the memory stick is shut down for safe removal.
The configuration file is automatically deleted from the memory stick after restoration, and the module reboots
for the new configuration to take affect.
NOTE: Wait a few minutes after the reboot completes to access to the unit.
Vertiv
| RPC2™ Communications Module Installer/User Guide |
26
Summary of Contents for LIEBERT RPC2
Page 57: ...Vertiv RPC2 Communications Module Installer User Guide 53 ...
Page 58: ......
