Vertiv Liebert IntelliSlot Unity Card, Installer And User Manual

Page: 12 / 74

The default node ID for a Unity card is 0, so the second card should use 1. A third card should use 2. A
fourth card should use 100 to 127. Contact your system administrator about the proper node ID for the
second card, then perform the following steps.
1. Open a Web browser and navigate to the second Unity card.
2. On the Communications tab, click
Configuration > Velocity Protocol > MSTP .
3. Click Edit and enter a password and username if needed.
4. Enter the new node ID.
5. Click
Save to confirm the changes or Cancel to discard them.
6. Restart the card:
a. On the Communications tab, click Support .
b. Click Enable .
c. Click Restart .
2.5 Security Best Practices
The default settings on the Unity card support a fast installation and start-up to get basic communication
services up and running quickly. Proper security of critical infrastructure equipment requires proper
configuration of ALL communication services. This section summarizes the settings to examine to reduce
the risk of unauthorized access to critical infrastructure equipment through a Unity card.
Table 2.1 on the facing page, provides a list of items to review. Each should be reviewed, configured
based on the operational needs for managing the equipment, and verified that the settings support the
desired operational functionality without adding unnecessary or unauthorized access to critical
infrastructure equipment. A reference to the proper section in this document is provided for configuring
each item.
ITEM DESCRIPTION REFERENCE
Accounts & Passwords
Change the admin and user account names and
passwords immediately to eliminate default
credential access.
Change User Names and Passwords
Immediately
on the previous page
IP Network Access
Enable/disable IPV4 and IPV6 network access
to the Unity Card - disable unused network
access.
Configure the Card on the previous page
Telnet and SSHv2 Access
Enable/disable telnet and SSHv2 access for
diagnostic and configuration support - disable
when not in use.
Network Folder on page 37
Web Service Protocol
Select HTTPS to use SSL encryption when
accessing data through the web user interface.
Web Server Folder on page 39
SSL Certificates
When using HTTPS, install your own SSL
Certificates from a trusted certificate authority
or generate alternative self-signed certificates
Certificate Folder on page 41
Password Protect Web Access
Enable to require users to log in before any
device information is displayed to the user.
Web Server Folder on page 39
Table 2.1 Settings to review and verify to reduce the risk of unauthorized access
Vertiv™ | Liebert® IntelliSlot Unity Card Installer/User Guide
8