Vertiv
| Liebert
®
EXM
™
Battery Cabinet User Manual |
8
1.5
Moving the Battery Cabinets
The battery cabinets should be moved with a forklift or similar equipment. The battery cabinet
has casters for movement over short distances. The bottoms of the battery cabinets are
reinforced to permit lifting by forklift to move them longer distances. The bottom structure will
support the unit only if the forks are completely beneath the unit.
The route between the point of arrival and the unit’s installation location must be planned to
make sure that all passages are wide enough for the unit and that floors will support its weight
(for instance, check that doorways, lifts, ramps, etc., are big enough and that there are no
impassable corners or changes in the level of corridors).
Ensure that the cabinet weight is within the designated surface weight loading (kg/cm
2
) of any
handling equipment. See
Tables 16
through
18
for weight details.
Ensure that any lifting equipment used to move the battery equipment has sufficient lifting
capacity.
Because the weight distribution in the cabinet is not symmetrical, use extreme care during
handling and transporting.
When moving the unit by forklift, care must be taken to protect the panels.
Handling the unit with straps is not authorized.
1.5.1
Raised Floor Mounting
If the equipment is to be placed on a raised floor, it should be mounted on a pedestal suitably
designed to accept the equipment’s point loading. Refer to the base view to design this pedestal.
WARNING
Risk of heavy unit falling over. Improper handling can cause equipment damage, injury or
death.
Exercise extreme care when handling battery cabinets to avoid equipment damage or
injury to personnel. The battery system cabinets weigh from 881 to 3341 lb. (400 to 1515kg).
Locate center of gravity symbols
and determine the unit’s weight before handling a
cabinet. Test lift and balance the cabinets before moving them. Maintain minimum tilt from
vertical at all times.
Read all of the following instructions before attempting to move, lift, or remove packaging
from unit, or prepare unit for installation.
AVERTISSEMENT
Le centre de gravité élevé de l’appareil présente un risque de renversement. Une mauvaise
manutention peut entraîner des dommages matériels, des blessures et même la mort.
Faites preuve d'une extrême prudence lors de la manutention des armoires ASC afin
d’éviter de les endommager ou de blesser le personnel. Le poids du module ASC varie entre
400 et 1 515 kg (881 et 3341 lb).
Identifiez les symboles de centre de gravité
et déterminez le poids de l'appareil avant
de manipuler chaque armoire. Testez le levage et l’équilibre des armoires avant de
transporter l'appareil. Maintenez en tout temps l'inclinaison verticale minimale.
Lisez toutes les instructions ci-dessous avant de tenter de déplacer, lever, déballer ou
préparer le système en vue de son installation.
