Vertiv 565050, Installation And User Manual

Page: 26 / 40

Vertiv
| eSure™ Power Extend Converter Installation and User Manual (UM565050) | Rev. D
26
distribution panel for the position to be occupied by the power
extend converter. At the same time, connect the power extend
converter return wire faston tab (P/N 565990) provided with the
power extend converter to the distribution panel return busbar
(use the same location and hardware used for the return lead to
the load). See
Figure 2 . Torque as indicated in Figure 2 .
[ ] 5. If the power extend converter is to replace an existing circuit
breaker, remove the circuit breaker and verify the load and return
cables for the position are wired and labeled correctly. It may be
advantageous to loosen and temporarily move the load side
cables for easier access to the hardware on the return landing
position studs. Connect the power extend converter return wire
faston tab (P/N 565990) provided with the power extend
converter to the distribution panel return busbar (use the same
location and hardware used for the return lead to the load). See
Figure 2 . Torque as indicated in Figure 2 .
[ ] 6. For return wire selection and installation routing, refer to the
instructions furnished with each mounting bracket kit. Mounting
bracket kit P/N 565391 with distribution panel 582127000 List
AA is used in
Figure 3 and Figure 4 . Refer to Table 3 for other
available kit P/Ns. General instructions are as follows:
a) If required , connect 4-inch long return wire extension P/N
565752 or 8-in long return wire extension P/N 566207
provided with the power extend converter to the return wire
faston tab P/N 565990 previously installed on the
distribution panel return bar.
b) Connect the return wire P/N 564330 provided with the power
extend converter to either the return wire extension installed
in a) above or to the return wire faston tab P/N 565990
previously installed on the distribution panel return bar.
[ ] 7. If the load side cables were disconnected in an above step,
reinstall and tighten those cables in the appropriate positions.
[ ] 8. Route the return wire (P/N 564330) down and behind the power
extend converter’s front mounting bracket, then connect it to the
power extend converter. See
Figure 4
. Orient the white square