Initial Configuration and Setup
Initial Configuration and Setup
The following list describes the recommended components and gives an abbreviated outline for
setting up a typical development system.
R
ECOMMENDED
C
OMPONENTS
•
EPM-CPU-10 Board Set
•
144-pin SODIMM SDRAM Memory Module (PC-66 or PC-100)
•
ATX Power Supply
•
SVGA Video Monitor
•
Keyboard with PS2 connector
•
3.5" Floppy Disk Drive
•
IDE Hard Drive
•
IDE CD ROM Drive (optional)
DRAM M
ODULE
•
Insert DRAM module into the SODIMM socket. Latch into place.
C
ABLES
/ P
ERIPHERAL
D
EVICES
•
Plug video adapter cable (p/n VL-CBL-1007) into socket JN2 and attach video monitor.
•
Plug keyboard into socket JS4[JC].
•
Plug floppy data connector JS3[JK] into floppy drive.
Note
The floppy drive used to boot the system (Drive A) should be connected after the
twist in the cable (connector JS3[JK]).
•
Plug hard drive data connector JS3[JH] into IDE hard drive.
•
Optionally, a CD ROM can be connected to JS3[JJ].
•
Plug power supply into JS1.
•
Attach power supply cables to external drives.
•
Jumper hard drive to operate as a master device.
6 – Configuration / Operation
EPM-CPU-10 Reference Manual