Configuration and Setup
EPM-32 Reference Manual
8
Figure 2. Typical Start-up Configuration
1. Install Memory
Insert the DRAM module into socket SODIMM1 (see Figure 9)and latch into place.
2. Attach Power
Plug the power adapter cable CBR-1008 into socket JS9. Attach the motherboard
connector of the ATX power supply to the adapter.
3. Attach Cables and Peripherals
Plug the video adapter cable CBR-1201 into socket JN3. Attach the video monitor
interface cable to the video adapter.
Plug the breakout cable CBR-8001 into socket JS5.
Plug a PS/2 keyboard into connector JC of the breakout cable and the a PS/2 mouse into
connector JB.
Plug the hard drive data cable CBR-4406 into socket JS4. Attach a hard drive and CD-
ROM drive to the connectors on the cable. If the hard drive is 3.5”, use the 2mm to 0.1”
adapter CBR-4405 to attach the IDE cable.
Attach an ATX power cable to any 3.5” drive (hard drive or CD-ROM drive).
Set the hard drive jumper for master device operation and the CD-ROM drive jumper for
slave device operation.
JS9
JS4
JS5
JN3
EPM-32
“Cheetah”
Analog
SVGA
Hard
Drive
CD-ROM
Drive
CBR-8001
CBR
–4406
JC
JB
ATX
Power Supply
CBR
–1008
CBR
–1201
PS/2 Keyboard
PS/2 Mouse
Power to
Drives
Operating
System
Installation
CD