Versalite OLD series, Setup Manual

Page: 5 / 10

5
Dome Camera Control
Dome Camera Connection & Settings:
•
See section Pin Definition of Alarm I/O & RS-485, and Audio In for RS-485 port pin definition.
•
Refer to the following figure. Connect the R+, R- terminals on the dome camera to the D+, D-
terminals on the RS-485 port by RS-485 cable respectively.
•
To set up dome camera’s protocol and ID, press MENU to access the OSD main menu, and
select < Camera Setup >. The available protocols include < DSCP >, < AD422 >, < Pelco D >,
< Pelco P >, < Fastrax 2 >, < JVC >, < Panasonic_C >, and < Panasonic_N >. The default is
< None >. Note that ID number must match the ID address defined by the dome camera.
•
To configure the RS-485 parameters, select < System Setup > from OSD main menu, and then
select < RS485 Setup >. The default RS-485 settings are 9600 Baud, 8 Data Bits, 1 Stop Bit and
No Parity.
Control Buttons in Dome Camera Control Mode:
1 Set / Go Preset 5 Focus Near 9 Go Presets 1~6 13 Pan / Tilt
2 Toggle Hint Screen 6 Zoom In 10 Iris Close
3
Enter Dome Camera
Control Mode
7 ESC 11 Focus Far
4 Iris Open 8 Enter / Auto 12 Zoom Out