107
Appendix E
Command Line Interface
Overview
If desired, the command line interface (CLI) can be used for configuration. This provides the
possibility of creating scripts to perform common configuration changes. The CLI can use a
remote connection via Telnet, or a physical connection from your PC to the serial port (RS232
port) on the Wireless Access Point.
Using the CLI - Telnet
1.
Start your Telnet client, and establish a connection to the Access Point.
e.g.
Telnet 192.168.0.228
2.
You will be prompted for the user name and password. Enter the same login name and
password as used for the HTTP (Web) interface.
The default values are
admin
for the User Name, and
password
for the Password.
3.
Once connected, you can use any of the commands listed in the following
Command
Reference
.
Using the CLI - Serial Port
1.
Use a standard serial port cable to connect your PC to the serial (RS232) port on the
Wireless Access point.
2.
Start your communications program. For example, in Windows, use HyperTerminal. (This
program may not be installed. If so, you can install it using
Start - Settings - Control Panel
- Add or Remove Programs
. Then select
Windows Setup
or
Add/Remove Windows Com-
ponents
, depending on your version of Windows.)
3.
Configure the connection properties:
•
Name
- use a suitable name, such as “AP”
•
“Port” or “Connect Using”
- Select the Serial Port that the cable is connected to.
(Do not select your modem.)
•
Port Settings
- Use 9600, N, 8, 1, with hardware flow control, as shown below.
E
