30
cleaning and maintenance
GENERAL RECOMANDATION
•
Important: Before any operation of cleaning and maintenance disconnect
the appliance from the electrical supply.
•
It is advisable to clean when the appliance is cold and especially for cleaning the
enamelled parts.
•
Avoid leaving alkaline or acidic substances (lemon juice, vinegar, etc.) on the
surfaces.
•
Avoid using cleaning products with a chlorine or acidic base.
• IMPORTANT: The use of suitable protective clothing/gloves is recommended
when cleaning and maintaining the appliance.
•
WARNING
When correctly installed, your product meets all safety requirements laid
down for this type of product category. However special care should be
taken around the rear or the underneath of the appliance as these areas are
not designed or intended to be touched and may contain sharp or rough
edges, that may cause injury.
ENAMELLED PARTS
•
All the enamelled parts must be cleaned with a sponge and soapy water only or
other non-abrasive products.
•
Dry preferably with a microfibre or soft cloth.
•
Acidic substances like lemon juice, tomato sauce, vinegar etc. can damage the
enamel if left too long.
PAINTED PARTS AND SILK-SCREEN PRINTED SURFACES
•
Clean using an appropriate product. Always dry thoroughly.
IMPORTANT:
these parts must be cleaned very carefully to avoid scratching and
abrasion. You are advised to use a soft cloth and neutral soap.
STAINLESS STEEL ELEMENTS
•
Stainless steel parts must be rinsed with water and dried with a soft and clean
cloth.
•
For difficult dirt, use a specific non-abrasive product available commercially or a
little hot vinegar.
INSIDE OF OVEN
The oven should always be cleaned after use when it has cooled down.
The cavity should be cleaned using a mild detergent solution and warm water.
Suitable proprietary chemical cleaners may be used after first consulting with the
manufacturers recommendations and testing a small sample of the oven cavity.
Abrasive cleaning agents or scouring pads/cloths should not be used on the cavity
surface.
NOTE:
The manufacturers of this appliance will accept no responsibility for damage
caused by chemical or abrasive cleaning.
Let the oven cool down and pay special attention no to touch the hot heating
elements inside the oven cavity.
Do not use steam jet cleaners
because the humidity could
infiltrate into the appliance
making it dangerous.
Do not use harsh abrasive
cleaners or sharp metal
scrapers to clean the oven
door glass since they can
scratch the surface, which
may result in shattering of
the glass.
WARNING
VERY IMPORTANT
Before any operation of
maintenance
disconnect
the appliance from the
electrical main supply.
WARNING !!
Do not store flammable
material in the oven or in
the warming drawer.
6
