20
Vermont Castings • Intrepid II Installation & Operating Manual_R48 • 11/17
3-90-2000966
ST516
Attach
griddle handle
11/17/00 djt
Figure 31
- Attaching the griddle handle.
ST518
Intrepid II
controls
11/20/00 djt
Air Control Lever
Griddle
Handle
Damper Handle
Door Handle
Door Handle
Holder
(Behind Leg)
Ash Pan
Andiron
Figure 32
- The Intrepid II controls.
Figure 30
- Attach the temperature probe.
Remove the fastener
and install the bracket.
Re-install the screw.
Fold bracket strap over
catalyst probe shaft and
screw with screw.
Remove the hole plug and
insert the catalyst probe
through cast iron back, twist
and push through fiber panel.
Smoke and CO Detectors:
The use of smoke and carbon monoxide (CO) detectors
throughout the home is strongly advised, even if not
required by building codes or insurance regulations.
It is a good idea to install a smoke detector in the living
areas and each bedroom. Follow the smoke/CO detector
manufacturer's placement and installation instructions and
maintain regularly.
You may not, however, wish to install a detector in the
immediate vicinity of the stove. Depending on the sensitivity
of the unit, the alarm can be set off while you are tending
the fire or emptying the ashes. If you install a detector in the
same room, locate it as far away from the stove as possible.
Safety Tips:
Conveniently locate a "Class A" fire extinguisher to contend
with small fires. Be sure the fire extinguisher works and
is clearly visible. All occupants of the house should know
where it is, and how it operates. Have heavy stove gloves
available near the stove. Have special safety accessories
(e.g., Child Guard Screen) available for use if small children
will be in the home.
In the event of a stove pipe or chimney fire….
• Evacuate the house immediately
• Notify the fire department
• If the fire isn't too threatening, closing down the stove
tight, (damper, primary air, all doors) will help to smother
the fire.
• Inspect your stove, stove pipe and chimney for any
damage caused by the fire and correct any damage
before using your stove again.
Attach the Griddle Handle:
Install the handle on the griddle. Place the griddle upside
down at the edge of a flat surface and assemble the handle
as shown. (Figure 31)
With the handle pointing 45° from its final position, tighten
the nut as far as possible with pliers. Move the handle to its
final position while still holding the nut with the pliers. Take
care not to overtighten, as tab may snap.
Attach the Catalyst Temperature Probe:
To install the catalyst temperature probe, remove the hole
plug from the cast iron wall and insert the probe. Referring
Figure 30, remove fastener on the right side of the stove.
Install the bracket and secure the probe to the bracket using
the #10 sheetmetal screw supplied.
