Connect the supplied ribbon-cable with its 10-pole connector to the corresponding multi-pin connector on
2.
randomRHYTHM’s rear (see Figure 1 on page 23)!
⚠︎
The corresponding plug socket is protected against reverse polarity. Therefore, the 10-pole
connector of the ribbon-cable will only fit in one direction into the module. The supplied
ribbon-cable is color-coded at the -12 volts position. Note, that this may differ from other
manufacturers. Therefore, only use the supplied ribbon-cable to connect randomRHYTHM
to your frame’s system bus!
Connect the ribbon-cable’s 16-pole connector to an empty plug-socket of your frame’s system bus! Make
3.
sure the color-coded side of the cable points towards -12 volts (see Figure 1: on page 23)!
⚠︎
Connecting the ribbon-cable with reverse polarity can lead to damage of your
randomRHYTHM or other modules when powering the system! Double-check the
connections before continuing – safe is safe!
Mount randomRHYTHM to your modular frame using the supplied screws! To protect the unit’s surface from
4.
scratches, use the supplied flat plastic washers.
Reconnect the power cord to your frame and switch on the power-supply. randomRHYTHM is now ready to
5.
operate.
User Guide randomRHYTHM
24
