RESET
Functions
C
and
D
specify the operating mode of the input
RESET IN
h
. Only one of the two functions can be
enabled per rhythm-section, since these functions are mutually exclusive. Without any function being activated,
the input
RESET IN
h
takes no influence on the corresponding rhythm-section.
C - RESET: MUTE ALL
With this function being enabled, the
RESET IN
input
h
allows to mute all trigger-outputs (
1/4
u
,
1/8
i
,
1/16
o
,
1/3
a
and
SEQ OUT
y
). Whenever a permanent, positive voltage above 2 volts is applied to input
RESET IN
h
, no
trigger-impulse will be send out to the corresponding outputs. Once the voltage drops below 2 volts, the outputs
will be released again.
D - RESET: RESTART DICE
This function is only active in dice-mode. With this function being enabled, a trigger-impulse (positive slope) can
be used to reset the active pattern to its start.
☛
The operating mode for RESET IN
h
may differ for the rhythm-sections 1 and 2. This leads
to interesting rhythmical effects.
For example: connect a square-wave-LFO to the RESET IN input
h
with RESTART DICE
activated for rhythm-section 1 and MUTE ALL activated for rhythm-section 2. At the LFO’s
rising slope, rhythm-section 1 is being restarted, while rhythm-section 2 is being muted for
the duration of the positive half-cycle of the square-wave. With the slope descending, the
trigger-impulses for section 2 are sent again.
EN
39
