Vermeer S925TX, Operator'S Manual

Page: 86 / 104

50-8 Operating the Machine S925TX Mini Skid Steer
Moving Machine with Load
• When moving the machine with a full bucket, go up or down slope with load (heavy end of machine) facing
top of slope. When moving the machine with an empty bucket, go up or down slope with bucket (light end of
machine) facing bottom of slope.
• Keep bucket level and as low as practical (carry position), raised only enough to clear any ground
obstructions.
• Watch terrain and avoid slopes, bumps, or depressions which could make machine unstable. Wherever
practical, drive directly up or down a slope or curb.
• Do not overload machine. Refer to “Load Capacities,” page 50-1.
• Avoid double stacked loads. Secure any load that could shift during movement.
• Additional safety information is provided in this section. Refer to “Driving Safety,” page 50-1.
• Do not step off operator’s platform when loader arms or attachment are raised. Machine stability is reduced
and may cause machine to tip forward when you step off.
Filling the Bucket
Step 1: Fully lower lift arms.
Step 2: Tilt bucket forward until cutting edge of bucket contacts the ground, and bottom of bucket is level with
the ground.
Step 3: Move machine forward slowly into the material while gradually tilting bucket backward as it fills.
Step 4: Move machine backward away from the material.