35-4 100 Service Hours
BC1000XL Brush Chipper Maintenance
U
PPER
F
EED
C
ONTROL
B
AR
F
ORCE
- A
DJUST
It should take 20–34 lb (9.0–15.4 kg) of force to move the Upper Feed
Control Bar out of forward feed to stop position at top of feed table.
Step 1:
Access adjustment nut (1) by removing Upper Feed Control
Bar shield (2).
Step 2:
Place a spring scale at the top and center of the Upper Feed
Control Bar (3) to check the force.
Step 3:
Loosen jam nut (4).
Step 4:
Tighten adjustment nut (1) to increase force; loosen it to
decrease force.
NOTE:
Adjust bolt so it takes 20–34 lb (9.0–15.4 kg) to move the bar
out of forward feed to stop position.
Step 5:
Retighten jam nut (4).
Step 6:
Replace Upper Feed Control Bar shield (2).
IMPORTANT:
When the Upper Feed Control Bar is placed in the stop
position, as shown, the feed roller must not turn.
1
2
3
4
3_04
Summary of Contents for BC1000XL
