Verizon Wireless Quantum FiOS-G1100, User Manual

Page: 20 / 212

SETTING UP
YOUR GATEWAY
• If connecting the WAN using coaxial cable,
locate a coaxial cable and connect one
end to the coax port on the back of your
Gateway. Connect the other end of the
coaxial cable to a coax wall jack.
Tighten the coaxial cables by hand until
snug. The cables should not require a
wrench.
4.
Plug the power cord into the power port on the back of
your Gateway and then into a power outlet. The Gateway
automatically turns on as soon as power is plugged in.
Important: Wait until the Power/Internet light on
the front of the Gateway stops fl ashing and is
solid white. If the light turns red, check the trouble-
shooting steps in the Troubleshooting section
of the user guide.
2.0b/ STEP 2 - CONNECT YOUR DEVICE TO YOUR GATEWAY
If connecting a device using wired Ethernet (preferred for initial setup):
• Plug one end of the supplied yellow Ethernet cable into one of
the four yellow Ethernet ports in the back of your Gateway.
Alternatively, you can use your own Ethernet cable of any color
to connect from the yellow Ethernet ports on the back of your
Gateway to your device with an Ethernet connector.
• Plug the other end of the yellow Ethernet cable into the Ethernet
port of your network device.