3.6
LIGHTING THE APPLIANCE (Remote Control Models)
a)
The Remote control handset generates an infrared signal, which will be
received by the sensor situated at the front right of your fire, behind the
black controls cover. This infrared signal requires direct line of sight
from the handset to the sensor on the fire to ensure good operation.
b)
To light the appliance using the handset, point the handset at the fire
and press the 2 left hand buttons together. The fire will emit a “beep”
sound, the buttons can now be released. After a few seconds an
audible clicking can be heard and then the fire will light the pilot and
then light the main burner. The ignition cycle will take approximately 20
seconds.
c)
To reduce the level of heat input on the fire, point the handset at the fire
and press the small flame button.
d)
To increase the level of heat input on the fire, point the handset at the
fire and press the large flame button.
e)
To leave the fire in the standby mode (pilot only running) press the small
round button on the handset.
f)
To switch the appliance off completely, press the large round button on
the handset, the fire will then switch off. See Fig. 29 for image of
handset.
Fig. 29
29
Off Button
High (Large Flame)
Low (Small Flame)
Standby Button
