Vantage 5000
1.4v-09.2019
27 | Page
1. CONTROL INTERVAL – sets a time in hours to trigger the
Control interval check. Setting a value of zero will disable
this feature. The pump will alert the user once the control
interval expires.
2. REMAINING ICON – shows the remaining number of
running hours before control interval alarm. It is a read-only
value.
3. RESET ICON – resets the remaining number of hours for
control interval. Once the icon has been selected, the user
will be prompted as per
Figure 20
.
4. JOB RUNNING TIME – shows the total number of running
hours for the Job File. If the Job File is changed, it will reset
and start again from zero once reactivated. It is a read-only
value.
5. RESET ICON – resets the running hours for the Job File.
Once the icon has been selected, the user will be prompted
as per
Figure 21
.
8
9
10
2
6
1
4
Figure 19 Editing Job File - Log Setup
7.4.5 Log Setup
6. COUNTER – shows the number of doses/batches which
have been completed since the Job File was activated. It is
a read-only value.
7. RESET ICON – resets the number of doses/batches which
have been completed with the selected Job File. Once the
icon has been selected, the user will be prompted as per
Figure 22.
8. ACCEPT
– accepts all changes within the Job File.
Changes made on this screen are not saved until this icon
is pressed.
9. GO BACK/CANCEL – cancels any changes and return to
the Job File Menu. If the user has made changes, there
will be a prompt asking the user if the changes should be
saved.
10. HOME – returns the user to the Home Screen. If the user
has made changes, there will be a prompt asking if the
changes should be saved.
Figure 20 Reset Control Interval
Figure 22 Reset Counter
3
7
Figure 21 Reset Counter
5
