4
2 The cord (see Figure 7)
• Open the cover of the conservatory awning.
• Dismount the cover from the pull frame.
•
Loosen the cord at the cord fixation block and loosen the fixation screw.
• Demount the covers of the rotary wheel blocks.
•
Block the connection between the left and right cord by sticking a screwdriver through the closure and pull frame.
There is a hole in the pull frame intended for this purpose.
Attention!
Maximum 4 cm above the values of the advise table.
In case of exceptional measures of the V610-Oslo take one
step higher in the table.
* The span length is the difference between
the tensioned spring and the spring without tension.
This can simply be measured.
Projection
Span length*
cm
cm
150
6
200 6
250
7
300
7
350
8
400
8
450
10
500
10
Rotary wheel block
B
2x
Side guide
Cord melter
Cord disk
Conservatory car
Mount the
bearing hub
1
2
3
4
5
7
9
6
8
0
Cord fixation block
Fixation screw
Check if the cords run
properly over the pulleys.
Warning!
There must be two strokes of cord
on the cord disk at all times.
Fig. 7
Subject to misprints, errors and technical modifications.
