Installation manual V610 Oslo
5
3
4
5
2
6
6
1
3 Optional: Linking the V610 Oslo (see Figure 8)
A linked V610 Oslo has a coupling pin already mounted in the motor section.
1. Place the part with the motor.
2. Demount the coupling pin. Therefore remove the allen screws M6 (1) on the plug at the motor side and remove
the strip (2).
3.
Link the V610-Oslo boxes by putting them against each other with the included fixation material.
4. Remove the allen screws M6 (1) on the part without the motor and take strip (2) away.
5. Remove the allen screws M6 (3), the strips (4) and the bearings (5).
6. Tightly turn the gag with fabric at the non-motor side. Due to transportation this gag can be twisted.
7. Place the axis with bearings.
Warning!
Make sure that the slots in both plugs (6) are oriented to the opening in the end caps.
8. Place the strips (2) back and tighten all screws M6 (1) evenly.
9. Place the strips (4) back and tighten them with the allen screws (3).
4 The cord, continued (see Figure 7)
• Place the cord on the rotary wheel block and pull it to the end of the side guide.
• Do the same at the other side.
• Then pull the cord to tension at a closed V610-Oslo according to the table in Figure 7.
Fig. 8
14010206-161103EN
