LW450 SETUP INSTRUCTIONS
Setup - 19
29. Place a 1/2” flat washer onto a 1/2 x 1” bolt (M).
Insert the bolt through the rear hole in the left
seat belt bracket, place the required number of
1/2” flat washers onto the bolt, and thread into
the end of the spacer rod (L).
30.
M
L
Tighten the 1/2” bolts that fasten the seat belt
brackets to the spacer rod.
31. Tighten the 3/8” bolts that fasten the seat belt
brackets to the power unit frame.
32. Place a 7/16” flat washer onto a 7/16 x 1” bolt (N)
and insert out through the mounting hole in the
right seat belt bracket. Install the seat belt latch (O)
onto the outside of the bracket and fasten with a
7/16” flat washer and a 7/16” lock nut (P). Tighten
until snug.
33.
N
O
P
Place a 7/16” flat washer onto a 7/16 x 1” bolt (N)
and insert out through the mounting hole in the left
seat belt bracket. Install the mounting flange (Q) of
the seat belt strap onto the outside of the bracket
and fasten with a 7/16” flat washer and a 7/16”
lock nut (P).
Q
N
P
Tighten until snug.
34. Move the primary SDLA lever to the float posi-
tion and check for clearance between the opera-
tor’s hand and the cab frame. If there is not
enough clearance, the SDLA linkage will need to
be adjusted.
35. Loosen the locking nuts (R) on the SDLA linkage
rods and turn to adjust the primary SDLA handle
in toward the operator. When the primary SDLA
lever is adjusted to the desired location, adjust
the secondary SDLA lever to match. Tighten the
nuts against the rod ends to lock in place.
36.
R
R
Reinstall the spacer washers and rubber
bumper onto the side dash panel and fasten
with the flange bolt through the cab frame and
side dash panel.
