Ventrac LE3200, Operator'S Manual

Page: 35 / 51

Service - 35
Changing the Headlight Bulb
1.
Avoid Personal Injury!
The headlight bulb contains gases under pres-
sure. The bulb may shatter if the glass is
scratched or dropped. Wear eye protection and
handle bulb with care.
Park power unit on a level surface.
2. Shut off engine and engage park brake.
3. Remove ignition key from switch.
4. Remove the two screws clamping the headlight
cover on (A) and remove cover.
5.
A A
A A
Disconnect ground wire from the defective head-
light (B).
6. Remove wire loom and shrink wrap from positive
wire (C) and disconnect the positive wire.
7.
B B
C C
D D
Remove the defective headlight from the light
assembly by pinching the wire spring fastener (D).
8. Install the new light bulb and secure with the
spring fastener.
9. Place heat shrink tubing over the positive wire.
10. Reconnect the positive and negative wires as
removed.
11. Slide the heat shrink tubing over the connector,
apply heat to shrink, and replace the wire loom.
12. Reinstall the headlight cover.
Changing the Taillights
1. Park the power unit on a level surface.
2. Shut off engine and engage park brake.
3. Remove ignition key from switch.
4. Disconnect the plug from the back side of the
taillight.
5. Push defective taillight assembly out of the
grommet and discard.
6. Insert the new taillight assembly into the grom-
met.
7. Plug in the taillight wire as shown in the fi gure
below.
SERVICE