DESCRIPTION
The Solo Pro fan is an extract fan for bathrooms and toilets specifically designed for
ducted applications. Pullcord, Timer, Humidity and PIR options are available.
ACCESSORIES
(not supplied)
WALL FITTING KIT
A range of white (stock ref. 254102) or brown (stock ref. 254100) 100mm wall kits are
available for installing into most walls using telescopic liners supplied.
WINDOW FITTING KIT
A window fitting kit is available. Stock reference 11461685.
A. INSTALLATION
PANEL/CEILING MOUNTING –
(FIG.4.)
1.
Cut a 105mm diameter hole.
2.
Remove the front panel by carefully pulling it away from the fan.
3.
Loosen the two self-retaining screws and remove the inner cover by carefully
pulling it away from the housing.
4.
Remove the impeller by carefully pushing the retaining clips together.
5.
Remove the PCB cover by loosening the two screws and pulling it out of the fan
housing.
6.
Mark the screw centres through the holes in the fan back plate. Drill, plug and
screw into position. Attach ducting as required for the installation.
7.
Wire the fan as described in Section B-Wiring. Adjust any settings as required
(see Section C-Setup).
8.
Replace the PCB and inner covers and impeller.
9.
After installation, ensure impeller rotates freely. Replace the front panel.
WALL MOUNTING – (FIG.4.)
1.
For wall mounting cut a 117mm diameter hole through the wall and insert the wall
sleeve. Slope the sleeve slightly downwards away from the fan. Where necessary
cut to length and cement both ends into position flush with the wall faces.
2.
Fix exterior grille into position with the louvres positioned downwards.
3.
Remove the front panel by carefully pulling it away from the fan.
4.
Loosen the two self-retaining screws and remove the inner cover by carefully
pulling it away from the housing.
5.
Remove the impeller by carefully pushing the retaining clips together.
6.
Remove the PCB cover by loosening the two screws and pulling it out of the fan
housing.
7.
Mark the screw centres through the holes in the fan back plate. Drill, plug and
screw into position.
8.
Wire the fan as described in Section B-Wiring. Adjust any settings as required
(see Section C-Setup).
9.
Replace the PCB and inner covers and impeller.
10. After installation, ensure impeller rotates freely. Replace the front panel.
