~ N
N
L
S
L
FAN
IMPORTANT:
Upon installation it is possible that the humidity controller will make the fan run
continuously until it has acclimatised to the environment. As part of the installation process it is
important to set/adjust the humidity sensitivity to the desired position. The controller is already
factory set to switch on at about 75% R.H.
PULLCORD OPERATION
The PULLCORD will activate the fan when switched. When the PULLCORD is switched into the
off position the fan will deactivate. The HTP model will return to the Auto sensing mode.
D. SERVICING AND MAINTENANCE.
WARNING: THE FAN AND ANCILLARY CONTROL EQUIPMENT MUST BE
ISOLATED FROM THE POWER SUPPLY DURING MAINTENANCE.
1. At intervals appropriate to the installation, the fan should be inspected and cleaned to
ensure there is no build up of dirt or other deposits.
2. Carefully pull the front panel off the inner grille. (fig. 4)
3. Wipe the inlets and front face with a damp cloth until clean.
The fan has sealed for life bearings, which do not require lubrication.
Fig.1 (Solo Pro)
Fig.2 (Solo Pro T/HTP)
Siting
the
fan.