2
Installation and Wiring Instructions
for the NBR High Pressure Axial Range of Extractor Fans.
IMPORTANT:
READ THESE INSTRUCTIONS BEFORE
COMMENCING THE INSTALLATION
DO NOT install this product in areas where the following may be present or occur:
•
Excessive oil or a grease laden atmosphere.
•
Corrosive or flammable gases, liquids or vapours.
•
Ambient temperatures higher than 40°C or less than –5°C.
•
Possible obstructions which would hinder the access or removal of the Fan.
SAFETY AND GUIDANCE NOTES
A.
All wiring to be in accordance with the current I.E.E.
Regulations, or the appropriate standards of your country
and
MUST
be installed by a suitably qualified person.
B.
The Fan should be provided with a local isolator switch
capable of disconnecting all poles, having a contact
separation of at least 3mm.
C.
Ensure that the mains supply (Voltage, Frequency, and
Phase) complies with the rating label.
D.
The Fan should only be used in conjunction with the
appropriate Vent-Axia products.
E.
The Fan should only be used in conjunction with fixed
wiring.
F.
When the Fan is used to remove air from a room containing
a fuel-burning appliance, ensure that the air replacement is
adequate for both the fan and the fuel-burning appliance.
G.
The Fan should not be used where it is liable to be subject
to direct water spray for prolonged periods of time.
H.
Where ducted Fans are used to handle moisture-laden air, a
condensation trap should be fitted. Horizontal ducts should
be arranged to slope slightly downwards away from the Fan.
I.
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.