22
Setup Steps
Humidity and Dehumidity (Setup Steps 48-54)*
Humidity Only With Heat (Setup Step 48)
When this step is set to ON, Humidity will not run without a demand for Heat.
Fan With Humidity Demand (Setup Step 49)
Specifies if the fan should be turned on with a demand for Humidity.
(This step will only appear if step 48 is set to OFF.)
Fan with Dehumidify (Set up Step 50)
Specifies if the fan should be turned on with a demand for Dehumidify.
(This step will only appear if step 81 is set to OFF.)
Humidity Setpoints (Setup Step 51)
Specifies whether the Humidity setpoint should be entered by the user (MANUAL) or determined
automatically by outdoor temperature (AUTO). An outdoor temperature sensor is required for the
AUTO
setting. If the outdoor temperature sensor stops reading while this step is set to
AUTO
, the
Humidity setpoint will revert automatically to a setting of 15 percent.
Cool To Dehumidify (Setup Step 52)
Specifies if the cooling equipment is allowed to turn on exclusively to lower room humidity.
(If set to
OFF
the following two steps will not appear.)
Max Dehum Overcool (Setup Step 53)
Specifies how many degrees below the Cool setpoint the air conditioning will run to satisfy a Cool to
Dehumidify demand. (0˚ - 20˚)
Reheat Operation With Cool To Dehumidify (Setup Step 54)
Specifies if electric strip heat is allowed to turn on during a Cool to Dehumidify demand to help
maintain desired room temperature. This step is not available if Electric Heat is not present.
Press the SETUP button, then press MODE repeatedly until the
desired setup step appears. Use the WARMER or COOLER buttons
to make selection. Press MODE to advance to the next step.
Press/hold MODE to go backwards to prior steps. Press SETUP to
leave the setup screens.
WARMER
COOLER
MODE
SETUP
